Torque Converter

Torque Converter lets you convert torque through the newton metre: value × source factor / target factor. Enter your own values or load the worked example.

Copy or download the computed result
Adjust value
See the processing method and limits

Method and calculation

Convert torque through the newton metre: value × source factor / target factor. Factors relative to newton metre: N·m = 1; N·cm = 0.01; lbf·ft = 1.3558179483314; lbf·in = 0.1129848290276; kgf·m = 9.80665.

Inputs and settings

Torque Converter accepts Value (minimum 0); From unit (N·m, N·cm, lbf·ft, lbf·in, kgf·m); To unit (N·m, N·cm, lbf·ft, lbf·in, kgf·m).

Worked example

Torque Converter example — Value: 1; From unit: "N·m"; To unit: "N·cm". Computed output: { "value": 100, "unit": "N·cm", "baseValue": 1, "baseUnit": "newton metre" }

Output and limitations

Torque quantifies the turning effect of a force acting through a lever arm. Although newton-metres also appear in work calculations, tightening torque is not energy consumption. Pound-inch and pound-foot differ by twelve; confusing them can produce a large fastener-setting error.

Technical references: NIST SI conversion factors

Torque Converter FAQs

How does Torque Converter work?

Torque Converter applies the following rule to your input: Convert torque through the newton metre: value × source factor / target factor. The worked example on this page uses the same processor as the result button.

What should I check in Torque Converter?

Torque Converter has these boundaries: The torque factors are fixed conversions. Unit labels specify the convention; no live data is fetched. Start by checking the value field against the units or format shown.

Can I try an example in Torque Converter?

Torque Converter provides this sample: { "value": 100, "unit": "N·cm", "baseValue": 1, "baseUnit": "newton metre" }. Use the sample button to reproduce it, then replace the inputs with your own values.